| Version 1 (modified by , 12 years ago) ( diff ) |
|---|
A brief Guide to Node Testing
The procedure is different for different generations of nodes. We'll break it up into two classes:
Old rabbit Based CM
- First locate the node4-11 Node ID box, it looks like
- Wire the control, CM, monitor, and keyboard to their respective ports
- Connect Power, the led on the top of the box should start flashing
- Connect via ssh to console.outdoor.orbit-lab.org
- Run
ssugrim@console.outdoor:~$ omf-5.2 stat INFO NodeHandler: init OMF Experiment Controller 5.2.408 ----------------------------------------------- INFO Topology: Loading topology 'system:topo:all'. Testbed : outdoor.orbit-lab.org . . . Node n_4_10 - State: NODE NOT AVAILABLE Node n_4_11 - State: POWEROFF Node n_4_12 - State: NODE NOT AVAILABLE -----------------------------------------------
Note the status of node 4-11. 1.Check the serial console by telneting to cons4-11 8023
New Lantronix Based CM
Attachments (2)
-
node_id_4-11.jpg
(658.5 KB
) - added by 12 years ago.
Node ID box
-
wire_node.JPG
(1.4 MB
) - added by 12 years ago.
Wired up node
Note:
See TracWiki
for help on using the wiki.
