Changes between Version 2 and Version 3 of Internal/Network/SBSwitches


Ignore:
Timestamp:
Feb 27, 2007, 8:01:37 PM (18 years ago)
Author:
anonymous
Comment:

—

Legend:

Unmodified
Added
Removed
Modified

  • Internal/Network/SBSwitches

    v2 v3  
    1 = Sanbox Switch =
     1= Sanbox/Outdoor Switch =
    22
    3 Each two-node sanbox has a 16 port Netgear GS716T Gigabit Smart Switch with the FQDN of sw-sbXX.orbit-lab.org (where XX is sanbox number 01-09). FOr each of the switches ports 1-4 are reserved for CM subnet, ports 5-8 for sanbox control subnet while ports 9-12 are reserved for sanbox data subnet. Ports 13-15 are assigned to network managemtn while port 16 is, as in the case of other Orbit switches, used for uplink.
     3Each two-node sanbox/outdoor setup has a 16 port Netgear GS716T Gigabit Smart Switch with the FQDN of sw-sbXX.orbit-lab.org (where XX is sanbox number 01-09) or sw-outXX.orbit-lab.org. On each switch ports 1-4 are reserved for CM subnet, ports 5-8 for sanbox control subnet while ports 9-12 are reserved for sanbox data subnet. Ports 13-15 are assigned to network management while port 16 is, as in the case of other Orbit switches, used for uplink.
    44
    55== Switch Configuration ==
    66
     7Make sure switch is connected with port 16 to untagged port on the upstream switch. Use !SmartWizard to set up default password, DHCP 
    78=== ===
    89=== ===
    … …  
    3031Configuration is done under the VLAN entry.
    3132
    32 Note: New switch has to be connected to the upstream switches untagged port for SmartWizard to even see it. Once new switch is configured with VLANs the upstream switch port should be configured for propper VLAN trunkning.
     33Note: New switch has to be connected to the upstream switches untagged port for !SmartWizard to even see it. Once new switch is configured with VLANs the upstream switch port should be configured for propper VLAN trunkning.