Changes between Version 105 and Version 106 of Documentation/CGettingStarted

Timestamp:

Jul 11, 2023, 12:51:50 PM (10 months ago)

Author:

jennyshane

Comment:

—

Documentation/CGettingStarted

@@ -33 +33 @@
   username@console:~$ omf load -t all -i baseline20.04.ndz
 }}}
-  We are using `all` for our set of nodes here because there are only two nodes in sb1. For a larger domain like grid, you should specify a list of specific nodes, like `node1-1,node2-1,node8-8`. '''Do not turn on all of the nodes in grid!'''
+  We are using `all` for our set of nodes here because there are only two nodes in sb1. For a larger domain like grid, you should specify a list of specific nodes, like `node1-1,node2-1,node8-8`. 
+  '''Do not turn on all of the nodes in grid! '''
   == 4. Turn the nodes on ==
   At this point the nodes' disks are imaged with the ''baseline'' image and need to be turned back on before proceeding. Use the `omf tell` command to turn the nodes on and give them a couple of minutes to boot, then check their status with `omf stat`.
-  [[Include(Documentation/Short/TellOn)]]
-  [[CollapsibleEnd]]
+
   == 5. Run your experiment ==
   In this example, our "experiment" will be to use one node as a wireless access point, which the other node will connect to. This is meant to demonstrate the basic way in which experimenters interact with testbed resources, along with