Changes between Version 4 and Version 5 of Tutorials/m0SDN/aHowTo


Ignore:
Timestamp:
Aug 13, 2009, 3:47:53 PM (15 years ago)
Author:
akoshibe
Comment:

—

Legend:

Unmodified
Added
Removed
Modified

  • Tutorials/m0SDN/aHowTo

    v4 v5  
    1313
    1414=== The Testbed ===
    15 Sandbox 9 consists of three nodes connected to the SB9 Console through a !OpenFlow enabled IP8800/S3640-48T2XW switch.
    16 [[Image(wiki:Documentation/OpenFlow/OFHowTo:OFSetup.jpg)]] 
     15Sandbox 9 consists of three nodes connected to the SB9 Console through a !OpenFlow enabled switch. The network topology is shown below:
     16[[BR]]
     17[[BR]]
     18[[Image(wiki:Documentation/OpenFlow/OFHowTo:OFSetup.jpg, 450)]] 
    1719
    1820=== The switch ===
    19 The switch is currently running firmware supporting !OpenFlow v0.8.9. The switch is pre-configured so that ports 25-36 (the data VLAN) is an !OpenFlow virtual switch that listens to the Console as the controller. The configurations can be altered by using the `setvsi` command in the switch's command-line interface.
     21The centerpiece to the setup is the !OpenFlow enabled NEC IP8800/S3640-48T2XW switch running firmware supporting !OpenFlow v0.8.9. The switch is pre-configured so that ports 25-36 (the data VLAN) is an !OpenFlow virtual switch that listens to a controller running on the Console. The configurations can be altered by using the `setvsi` command in the switch's command-line interface.
    2022The details behind configuring the virtual switch(es) on the IP8800 can be found [wiki:Documentation/OpenFlow/VirtualSwitch here].
    2123