Go back —> Tutorials

How to use execute an application on the nodes

This feature is only available in NodeHandler v4 and above.

Before going through this tutorial, you should know how to install a disk image.

You should also have installed a disk image with Node Agent v4 on the nodes of the testbed you are using (e.g. "baseline-7.11.ndz").

Goal

In this tutorial, you will learn a simple way to execute an application on the nodes of a testbed.

The tutorial experiment

This experiment is given in the attached script tut_app_1.rb​.

This file contains extensive comments that should help you understand the different steps involved in running an application on the nodes of a testbed.

For more information on the basics of writing and using an experiment script, please refer to the previous tutorials, here and here.

To run this example script, use the following command:

 nodehandler4 tut_app_1

(This assumes that you previously logged in to a testbed, and imaged its nodes with a disk image such as "baseline-7.11.ndz".)

The Results

The experiment screen output should then look like this. And the experiment log file should look like this.

More…

If you would like to use the same application but with different parameters (or with parameters that you would like to dynamically change during the course of the experiment), then you should consider using a "prototype" around your application, as explained in this other tutorial.