Changes between Version 2 and Version 3 of Old/Hardware/hNodes/cNodeVer3/dAssembly/bCM


Ignore:
Timestamp:
Sep 20, 2012, 3:07:33 PM (12 years ago)
Author:
Ilya Chigirev
Comment:

—

Legend:

Unmodified
Added
Removed
Modified

  • Old/Hardware/hNodes/cNodeVer3/dAssembly/bCM

    v2 v3  
    11 1. Wiring the CM:
    2   1. Attach the red and black power connector wires using the vampire clips to the purple and any black of the 24 pin ATX power supply connector respectively. See image below.[[BR]]
    3 [[Image(VampClip.jpg, 300)]]
    4   1. connect the red/black twisted pair cable to the motherboard, and the other end to the CM as shown in the pictures below. Do the same for the blue/black twisted wire pair. The header on the MB is next to the RAM and SATA connectors. [[BR]]
    5 [[Image(CmWire.jpg, 300)]]
     2  1. Attach the red and black power connector wires using the vampire clips to the purple and any black of the 24 pin ATX power supply connector respectively. See image below.[[BR]][[Image(VampClip.jpg, 300)]]
     3  1. connect the red/black twisted pair cable to the motherboard, and the other end to the CM as shown in the pictures below. Do the same for the blue/black twisted wire pair. The header on the MB is next to the RAM and SATA connectors. [[BR]][[Image(CmWire.jpg, 300)]]
    64
    7  1. Mounting the CM:[[BR]]
    8 [[Image(CmMount.jpg, 300)]]
     5 1. Mounting the CM:[[BR]][[Image(CmMount.jpg, 300)]]
    96  1. Attach the 3 6-32 hex stand offs to the cm card with the 3 6-32 pan head screws. the stand offs should be on the non-component side of the CM
    107  1. thread the other end of the serial cable between the 3 stand offs