Changes between Version 26 and Version 27 of Hardware/jCM/dCM3/cSoftware


Ignore:
Timestamp:
Sep 17, 2012, 3:30:08 PM (12 years ago)
Author:
Ilya Chigirev
Comment:

—

Legend:

Unmodified
Added
Removed
Modified

  • Hardware/jCM/dCM3/cSoftware

    v26 v27  
    2424After XML configuration is completed the CM3 will populate the network information back into variables set up in software. This is because a lot of the network information is only available through the XML configuration file and so to recollect it each time you need it takes a long time. The CM3 then sets up the HTTP commands, which allow some basic functions of the CM3 to be executed over XML, and the custom command line interface for the CM3, as described in the Usage section.
    2525
    26 ==== UDP ====
    27 UDP was the standard method off communicating commands between the CMC and the CM, however it has not been removed as a method of control. All commands from the CMC now go over XML. 
    28 
    29 ==== XML ====
    30 XML pages have been loaded onto lantronix device and return either success or failure wheh commands are entered through an http address.
    31 
    32 ==== CLI ====
    33 A custom command line interface (CLI) level has been added to the factory default CLI levels specific to the CM operations.
    34  
    3526==== Flashing Firmware ====
    3627There are two primary methods to reflash a CM3, over the network and also through the serial port. This section will describe how to load new firmware onto the device using both methods. The latest 'known good image' can always be found on the [http://www.orbit-lab.org/browser/CM3/trunk/images SVN Repository]