Changes between Version 5 and Version 6 of Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C


Ignore:
Timestamp:
Jun 14, 2011, 5:19:15 PM (13 years ago)
Author:
ssugrim
Comment:

Legend:

Unmodified
Added
Removed
Modified
  • Hardware/hNodes/cNodeVer3/dAssembly/cBios/aLV67C

    v5 v6  
    4545 1. The power supply sits in the open area to the left (looking at the rear) of the mother board. It will be secured to rear face plate when the it is installed. The power supply is not attached to the main U chassis however it must be inserted before installing the face plate. The power headers should be connected at this point. When sliding the power supply into place, separate the yellow/black 4 pin plug from the rest of the cables and thread it below the cpu heatsink (it's important to thread the wire below other wise it will get stuck in the cpu fan). Connect 4 pin plug it to the extra power header behind the PS/2 keyboard/mouse riser.
    4646 1. Attach the mother board face plate to the opening on the rear face plate cap. It should be open on the right side (to allow for a expansion card) and closed on the left (as close to the power supply opening as possible). 
    47  1. Mount the rear cap on the U channel Chassis. Fasten it with 2 of the 6-32 1/4" 100 degree screws on the bottom. Next use two more of 100 degree screws and attach the bottom holes power supply to the rear cap. Use the 6-32 1/4" pan head screw to fasten the top of the power supply (near the 3 prong power header) to the rear cap.Bolt all the Sma headers to the face plate.
     47 1. Mount the rear cap on the U channel Chassis. Fasten it with 2 of the 6-32 1/4" 100 degree screws on the bottom. Next use two more of 100 degree screws and attach the bottom holes power supply to the rear cap. Use the 6-32 1/4" pan head screw to fasten the top of the power supply (near the 3 prong power header) to the rear cap. Bolt all the sma headers to the face plate. The convention used is that header 1 of the wimax card goes to the left most (closest to the power supply) hole. header 2 immediately to the right of connector 1. Finally, the !WiFi header of the 802.11 card goes to the right most hole.
    4848----
    4949== How to connect up power/disk headers and Flash The LV67-C bios == #Lv67cBios
     
    5555== How to install the Disk and close the case == #Disk
    5656 1. Attach the M3 5mm hex stand offs to the hard dive using the bottom holes. Align these stand offs with the holes on the right side of the front face plate (facing front), make sure to orient the drive so that the header point to the left (towards the inside of the case). Fasten the disk, stand off assembly to the face plate with the M3 5mm pan head screws.
    57  1. Attach requite power and sata cables. Mount the rear face plate using the three 6-32 1/4" 100 degree screws on the sides and bottom. 
     57 1. Attach requite power and sata cables. When attaching the sata cable to the mother board, use the header closest to the CPU (sata1)
     58 1. Mount the rear face plate using the three 6-32 1/4" 100 degree screws on the sides and bottom.   
    5859 1. use the remaning screws to attach the top cover. The rear of the top cover should go below the cap.
    5960