Changes between Version 15 and Version 16 of Hardware/dInfrastructure/qPowerMeasurment


Ignore:
Timestamp:
Aug 23, 2013, 11:39:04 PM (11 years ago)
Author:
pavan717
Comment:

—

Legend:

Unmodified
Added
Removed
Modified

  • Hardware/dInfrastructure/qPowerMeasurment

    v15 v16  
    102102'''Current Progress:'''
    103103
    104 The ORBIT grid has total of 400 nodes out of them 301 are functional and 99 are not functional. They all are connected to total of 34 breaker switches, approximately 12 nodes to a breaker switch. One Power Sensing Arduino board can only take in 12 inputs.    
     104The ORBIT grid has total of 400 nodes out of them 301 are functional and 99 are not functional. They all are connected to total of 34 breaker switches, approximately 12 nodes to a breaker switch. One Power Sensing Arduino board can only take in 12 breaker switches out of 34, therefore the current sensor has only the first 12 breaker switches connected covering the area shown in the black box below: [[BR]]   
    105105
     106|| [[Image(Node Mapping.PNG, 400px)]] ||
     107|| Figure : Chip Off-Set  ||
     108[[BR]]
    106109
     110The numbers in the blue circle above represent each outlet, approximately 3 outlets are connected to a single breaker switch.  The outlets are numbered because they have to be mapped to the proper breaker switch. Because 4 nodes are connected to a single outlet, the mapping was done by turning on/off 4 nodes at a single outlet and reading & recording the power the spike at any breaker switch to determine which breaker switch was connected to which outlet. 
    107111