For this tutorial, use the Y option when calling doing SSH. First you are going to want to resolve a space on SB3 before continuing on with the tutorial.

ssh -Y username@sb3.orbit-lab.org

Check that the nodes are powered ON:

omf stat -t all

If one or both of the nodes are in a powered off state turn them on with:

omf tell -a on -t all

Next to get the latest updated image with updated gnuradio libraries enter:

omf load -t all -i ubuntu-14-04-64bit-sdr-full.ndz

After calling the nodes will power down after imaging. Turn them back on and enter:

ssh -Y root@node1-1

*Note if this doesn't work the first time, the node might be recovering from imaging. Wait a few seconds and try again.

Enter on the command line:

gnuradio-companion &

Once opened configure the following with the necessary blocks:

Compile and run the configuration and you will get the following output with a slider to adjust the frequency of the input sinusoid.