Changes between Version 11 and Version 12 of Tutorials/g0WmLTE/Tutorial4-OAI

Timestamp:

Mar 4, 2015, 8:54:47 PM (9 years ago)

Author:

shsagari

Comment:

—

Tutorials/g0WmLTE/Tutorial4-OAI

@@ -259 +259 @@
 1. -O file: eNB configuration file (this is the preferred way to pass basic parameters and there are several examples in $OPENAIR_TARGETS/PROJECTS/GENERIC-LTE_EPC/CONF/
 1. -g LEVEL: set the level of debug for the log generation (-g7 is quite high and useful to trace bugs in the procedures/protocols, -g9 even dumps packets at all levels of the protocol stack)
-
-[[CollapsibleStart(The command line parameters of lte-softmodem)]] 
-{{{
-1. -O file: eNB configuration file (this is the preferred way to pass basic parameters and there are several examples in $OPENAIR_TARGETS/PROJECTS/GENERIC-LTE_EPC/CONF/
-}}}
-[[CollapsibleEnd]]
+1. -d: enables xforms signal tracer
+1. -U: start as UE (default: eNB)
+1. -C freq: set carrier frequency to f0 for all chains (extension to independent frequencies trivial)
+1. -V: enables the VCD debugging tool (this is a temporal event tracer, which is useful for real-time debugging using GTKWave)
+1. -K file: ITTI logfile. ITTI is an intertask tracing utility which helps debugging with an EPC. It can traces all exchanges between RRC<->S1AP, RRC<->PDCP, PDCP<->S1
+1. -S: do not exit for the missing slots, instead increment the counter.
+1. --debug-ue-prach: only send prach but do not connect
+1. --no-L2-connect: only runs rx, does not send prach