Changes between Version 4 and Version 5 of Hardware/hNodes/cNodeVer3/dAssembly/cBios/abLV67J

Timestamp:

Dec 5, 2013, 5:59:05 PM (10 years ago)

Author:

Ilya Chigirev

Comment:

—

Hardware/hNodes/cNodeVer3/dAssembly/cBios/abLV67J

@@ -58 +58 @@
 
 [http://www.paoloiannelli.com/tag/flashdisable/]
+
+STUB
+
+For use as console:
+Making Switch:
+
+1. Take switch from bin
+2. Cut 4 wires, 24awg, 2 black, 1 blue, 1 red
+3. Strip ends of wires, short on 1 side, about 1cm on other
+4. crimp short molex pins onto ends
+5. solder other ends to switch.
+ 1. Blue to terminal by mark (led positive)
+ 2. Black opposite it.
+ 3. Other two terminals get red and black, orientation doesn't matter. (switch)
+6. cut heat shrink to length, slide over wires down to terminal
+7. shrink
+8. twist wire pairs to keep separate
+9. plug pins into molex terminals.
+ 1. red/black to 2 pin
+ 2. blue/black to ends of 3 pin
+
+
+
+
+====== BIOS Settings (bios version 1.1J): ======
+* Main
+ * Boot Features (get right name)
+  1. Quick Boot (ON)
+  2. Console Redirection (ON)
+   * Terminal Type (ANSI)
+  3. UEFI Boot (OFF)
+* Advanced
+ 1. Processor Configuration
+  1. Intel (R) HT Technology (ON)
+  2. Intel (R) Virtualization Technology (ON) (Default)
+ 2. System Agent Configuration
+  1. Intel VT for directed IO (ON)
+ 3. Network Configuration
+  1. LAN OPROM Selection (ON)
+  2. Wake on PCH LAN (OFF)
+ 4. AMT Configuration (Maybe needed, built in serial over lan?)
+  1. Disable
+ 5. ME configuration
+  1. Disable
+* Other
+ 1. SIO config
+  1. Paraller port (disabled)
+ 1. Hardware Monitor
+  1. CPU warning temp (90C)
+  1. Fan control (by temperature)
+  1. Fan control threshold (40c)
+* Boot Order
+ 1. Usb Hdd
+ 1. If Network card
+  1. 0100
+ 1. If no network card
+  1. 00C8
+ 1. Hdd0
+
+
+====== Flashing BIOS ======
+
+backup first
+
+from readme:
+Flash Method:
+
+1. Please make a boot-able Disk which could booting into DOS environment.
+2. Un-zip attached files and copy it into boot-able Disk.
+3. Power on the system and flash the BIOS under the DOS environment.
+ 1. First, Backup the current BIOS FPT -D nodeXX-XX-bak.bin
+ 2. The instruction will be "C:/fpt -savemac -f 67J12.BIN"
+4. Please turn off the system and clean CMOS by Jumper.
+5. Turn on the system and update BIOS successful.