Changes between Version 6 and Version 7 of Hardware/bDomains/cSandboxes/dSB4

Timestamp:

Dec 21, 2011, 2:12:01 AM (12 years ago)

Author:

seskar

Comment:

—

Hardware/bDomains/cSandboxes/dSB4

@@ -1 @@
-[[TOC(Documentation/Topology/*)]]
+[[TOC(Hardware/gDomains/*)]]
 
-= Topology Control in SB4 =
+= SB4 =
 
 As shown in Figure 1, sandbox 4 consists of 8 nodes and a WiMAX subsystem that consists of a basestation and a controller. To prevent interference, each node is housed in [http://www.ramseytest.com/ Ramsey Electronics RF enclosure] that provides 80 dB of isolation. Nodal wireless devices (Atheros 5000X mini-PCI card and Intel 6250 mini-PCIe 802.11/802.16) are connected to a power combiner and fed through the enclosure access port to the outside SMA connector which is wired to a single input/output of the ports of the [wiki:Documnetation/Topology/aRFControl RF Transceiver Test System] from [http://www.jfwindustries.com JFW Industries]. This configuration enables fairly tight control of RF attenuation between the nodes. The topology is controlled through the [http://omf.mytestbed.net OMF] based [wiki:Documentation/Services/bInstrumentationControlService Instrumentation AM].
 
 [[Image(SB4.jpg, 600px, link=, align=center)]]
-
-Basestation is controlled through  [http://omf.mytestbed.net OMF] based [http://wimax.orbit-lab.org/wiki/WiMAX/17#a9.WiMAXRFAggregateManagerService WiMAX RF Aggregate Manager Service] that is running on machine cons-wm-01.
-
-Example of topology control (execute on console.sb4):
-
-To set attenuation between node1-8 and the BS to 20 dB
-{{{
-    wget -O status.xml "http://internal2dmz.orbit-lab.org:5052/instr/set?portA=8&portB=9&att=20"
-}}}
-
-Example of wimax control (execute on console.sb4):
-
-To turn ARQ on ([http://wimax.orbit-lab.org/wiki/WiMAX/17/01arq#arq-ARQControl ARQ Control] part of wimaxrf AM) 
-{{{
-    wget -O status.xml "http://cons-wm-01:5052/wimaxrf/arq?enable=true"
-}}}