Changes between Version 34 and Version 35 of Hardware/bDomains/cSandboxes/dSB4

Timestamp:

Aug 5, 2015, 8:04:51 PM (9 years ago)

Author:

seskar

Comment:

—

Hardware/bDomains/cSandboxes/dSB4

@@ -6 +6 @@
   || [[Image(SB4.jpg, 600px, align=center)]] || [[Image(IMG_0376.jpg, 200px)]] ||
 
-As can be seen in figure 1, there are a total of nine (9) input/output ports on the transceiver test system. The first 8 input/output ports are connected to nodes 1 thru 8, respectively and the 9th input/output port is connect to the Wimax base station (BS). 
+As can be seen in figure 1, there are a total of nine (9) input/output ports on the transceiver test system. The first 7 input/output ports are connected to nodes 1 thru 7, respectively while the 8th and 9th input/output ports are connect to  either nodes 1-8 and 19 or the two Wimax base stations (BS1 and BS2). The selection of ports 8 and 9 is controlled through [wiki:/Software/eAM/mInstr Instrumentation AM] service. 
 
  || RF Test System Port || Attached device || 
@@ -16 +16 @@
  || 6 || node1-6 || 
  || 7 || node1-7 || 
- || 8 || node1-8 || 
- || 9 || wimax BS ||
+ || 8 || node1-8 or wimax BS1 || 
+ || 9 || node1-9 or wimax BS2 ||
 
 This configuration creates two distinct set of RF paths that are used to create various topologies.