Changes between Version 26 and Version 27 of Documentation/CGettingStarted

Timestamp:

Feb 15, 2006, 5:42:39 PM (18 years ago)

Author:

Surya Satyavolu

Comment:

—

Documentation/CGettingStarted

@@ -36 +36 @@
 
 When you have successfully logged in, you can start an experiment using the [wiki:NodeHandler nodehandler]. First time users are '''highly''' encouraged to reserve time on a sandbox instead of the main grid, and start with the built-in ''Hello World'' experiment. 
-* Prior to the experiment, users need to install the baseline image on the hard disks of the nodes. This process will soon be done by the system before a slot is approved so that users can directly start the experiment with their preferred image on the nodes
+ * Prior to the experiment, users need to install the baseline image on the hard disks of the nodes. This process will soon be done by the system before a slot is approved so that users can directly start the experiment with their preferred image on the nodes
 
 [[Image(howto2.PNG)]]
@@ -52 +52 @@
 [[Image(howto4.PNG)]]
 
-This experiment will send UDP datagrams of 1024 bytes from node 1-1 to node 1-2 at 300 kbps CBR traffic. Both, sender and receiver, report measurements to a database, using our [wiki:OML OML] measurement framework.
+ * This experiment will send UDP datagrams of 1024 bytes from node 1-1 to node 1-2 at 300 kbps CBR traffic. 
+ * Both, sender and receiver, report measurements to a database, using our [wiki:OML OML] measurement framework.
+ * As shown below, the experiment controller will power on the nodes involved in the experiment and will issue experiment commands to each node.
+ * Each experiment has a unique experiment ID as shown in the figure, that can be used later to view the results from the database
 [[Image(howto5.PNG)]]