[orbit-user] Problem with node 1-2 in grid

[Yu Zhang]

Hi,

I found there is a problem with node 1-2 in the grid. I tried to image
the node for a few times, it always failed.

Even if it shows active in the grid status, when I telnet it, it shows

/dev # shutdown -h now
umount: Cannot remount /dev/ram0 read-only
umount: /: Device or resource busy
The system is going down NOW !!
Sending SIGTERM to all processes.
udhcpc[53]: Received SIGTERM
udhcpc[88]: Received SIGTERM
Terminated

At the end of imaging process, it shows

/dev # hda: dma_timer_expiry: dma status == 0x21
hda: DMA timeout error
hda: dma timeout error: status=0xd0 { Busy }
ide: failed opcode was: unknown
hda: DMA disabled
ide0: reset timed-out, status=0xd0
hda: status timeout: status=0xd0 { Busy }
ide: failed opcode was: unknown
hda: drive not ready for command
ide0: reset timed-out, status=0xd0
end_request: I/O error, dev hda, sector 5733504
end_request: I/O error, dev hda, sector 4101232
Buffer I/O error on device hda, logical block 512654
lost page write due to I/O error on hda
end_request: I/O error, dev hda, sector 4101240
Buffer I/O error on device hda, logical block 512655
lost page write due to I/O error on hda
...................................


When I tried to turn it on, everything went fine until the GNUB
loading. It shows

GRUB loading, please wait...
Error 2

I am thinking that this node has some problems.

Thanks a lot,

Yu