ORBIT-USER: Error setting bit-rate?

[Sachin]

lsmod should show "ath_pci"

On 1/19/07, Andrea G Forte <andreaf at cs.columbia.edu> wrote:
> How do I check if the driver is loaded?
>
> -Andrea
>
>
> Sachin wrote:
> > Hi Andrea,
> >
> > Some basic checks:
> >
> > - How are you setting the frequencies and bitrates? which commands are
> > you using?
> > - Have made sure that the driver is loaded prior to access the device
> >
> >
> > On 1/19/07, Andrea G Forte <andreaf at cs.columbia.edu> wrote:
> >> Hi all,
> >>
> >> I am using the orbit handler and after I turn on the nodes and try to
> >> set channel and bit-rate, I get the following:
> >> Error for wireless request "Set Frequency" (8B04) :
> >>     SET failed on device ath0 ; Invalid argument.
> >> Error for wireless request "Set Frequency" (8B04) :
> >>     SET failed on device ath0 ; Invalid argument.
> >
> >> Error for wireless request "Set Bit Rate" (8B20) :
> >>     SET failed on device ath0 ; Invalid argument.
> >> Error for wireless request "Set Bit Rate" (8B20) :
> >>     SET failed on device ath0 ; Invalid argument.
> >>
> >> Any idea why this is happening?
> >> Thanks a lot,
> >> -Andrea
> >>
> >>
>
>